Newest Products

This is a replacement Team Associated Metal Gear Differential Rebuild kit, suited for use with the B64 4-Wheel Drive buggy. 

A replacement Team Associated Roll Bar Hardware package, suited for use with the B64 4-Wheel Drive buggy.

Team Associated B6 Factory Team Aluminum Bulkhead. This is an optional aluminum bulkhead for the RC10 B6 and B6D buggies. This bulkhead weighs 10 g...

Arrowmax Turnbuckle Wrench. Select Size in drop down menu.

Shopping for someone else but not sure what to give them? Give them the gift of choice with a Team EAM, Inc gift card. Gift cards are delivered by ...

Super Clippers for trimming plastic and wire

Racers Edge Tire Tuning Scissors for cutting pins.

This is a replacement Team Associated T5M Rear Arm Set. This set includes a left and right side arm. 

This is a replacement Team Associated T5M Front Arm Set. This set includes a left and right side arm. 

Up to this point, e-Rustler, e-Stampede, Slash & Bandit owners have relied on bushings or undersized, weak bearings to handle the punishing cho...

This is a set of two replacement steering blocks from Traxxas. These steering blocks mount the the front uprights, and support the front axles.

This is a pack of two replacement Traxxas 30° Caster Blocks. Package includes left and right side caster blocks.

Factory Team Fluid Carrier This handy carrier will transport 16 of your favorite fluid bottles in neat compartments. The zipper enclosure keeps co...

XRAY 2 Hole Piston, 1.6mm, Flat XRAY 2 Hole Piston, 1.7mm, Flat XRAY 3x1.4 Piston, Flat CNC Machined Delrin (TM), perfectly round Tight fit to sho...

B6 FT Blue Aluminum Rear Hubs The new Factory Team aluminum rear hubs offer the ability to run 67mm CVA bones for increased rear support under low...

FT Aluminum Servo Horn 23T, 15.5 mm FT Aluminum Servo Horn 25T, 15.5 mm

B6 Front Bulkhead assembly

This is an optional XRAY 1.0mm XB2 Anti-Roll Bar Set, including a 1.0mm bar and the necessary mounting hardware. 

This is a replacement XRAY 4.9mm Aluminum Ball End Set, and is intended for use with the XRAY T2 '09, and T3 vehicles. These ball ends are the same...

 MIP hex wrenches are precision ground with Diamond wheels for accuracy and unmatched strength. This Hex Driver features the classic Thorp polycarb...

This is a replacement Savox SC1251MG Metal Gear Set with pre-installed Bearings.

This is a pack of four Arrowmax 4mm Aluminum 1/10 Set-Up System Wheel Nuts. These can be used to secure your 4mm axle equipped vehicle into a setup...

Balance charging LiPo batteries is one of the best ways to prolong the life of your LiPo battery and achieve maximum performance. Reedy's charge ha...

Blackbox Pro Modified Capacitor Unit