Newest Products

Replacement sensor board for all R1 motors (V16, V15, V11, V7)

CNC-machined alu tool for assembling composite ball joints onto steering rods. Very small and lightweight, yet very handy and easy to use. Black co...

The tool stand features multiple machined holes for tools and smaller diameter holes to hold various equipment such body reamers, clutch tools, pli...

Precision-molded 20T layshaft pulley made of specially-formulated graphite composite material that is a perfect balance of reliability and performa...

APEX Raceway 2024 Edition

Team EAM Spool axles.

Gravity RC Tire Balancing Clay

High velocity 30mm fan inlet provides and increases in volume from your std 30mm fan.  This results in an increased cooling effect by consuming a h...

Front chassis brace has shown to Increase steering response, corner speed and a more direct feel in high bite conditions. Available in  black Nylon...

C25 Steering Stiffener Carbon brace to tie the top of the bell crank together Reduces flex

AM19FX - Upper Arm Holder x 2 Providers a longer link than AM19, similar to AM18-1 or the FFG links

Specifications Japanese SUS 420J2 stainless steel curved blades with heat treatment. Precision ground blades for a sharp edge and smooth cutting...

Product Overview The Avid 12mm Hex Track Width Spacers are a great way to adjust the width on any car using 12mm hexes with 5mm axles or less...

This is a bearing kit by Avid RC for the Awesomatix A800. Optional Bearings Bearing Kit doesn't include the steering rack or belt tensioner bear...

Avid  Titanium Ball Studs are specially designed for the Xray line of vehicles such as the T4 and XB4 to minimize weight without sacrificing streng...

Triad Wing Buttons were designed after the success of our other 8th and 10th scale lineup. Coming in at 0.3g each (half the weight of our current 1...

 Does NOT include sensor board APPLICATION: ALL R1 WURKS V16 MOTORSTECHNOLOGY: MADE OUT OF ALUMINUM  OR TITANIUM VS. STANDARD STEEL FOR...

TECHNOLOGY: HIGHEST TORQUE IN THE INDUSTRYENHANCED PUNCH ROAR Approval pending *** Some rotors have "12.5" inscribed on the shaft due to a manu...

The Protoform AMR-12 had been exhaustively tested in preparation for these rule changes and the body has actually shown an increase in performance ...

This is a pack of four pairs of JR style servo connectors. Included are four female and eight male connector housings and eight sets of connector p...

This is a ProTek R/C "TruTorque" Metric Power Tool Tip Set, with 1.5, 2.0, 2.5 and 3.0mm tips. No one wants to spend money on low quality tools. To...

This is a 1.5mm ProTek R/C "TruTorque" Metric Ball End Replacement Tip and is intended for use with the ProTek R/C TruTorque 1.5mm ball end hex dri...

This is a pack of two replacement Protoform Better Edge: Sanding Drum 120-Grit Silicon Carbide Sanding Drum Bands. These are replacements for the P...

The Strakka-12 is a reduced-downforce alternative to the ultra-successful AMR-12. This race body will help your 1:12 Stock or SuperStock car slip a...