XRay

This is an optional XRAY ECS "Extra Strong" Driveshaft. Featuring Hudy Spring Steel, this ECS shaft was developed for all T2/T3/T4 cars as a direct...

The foam spacer battery is used to move the battery pack either front or rear to adjust the weight balance. Depending on the position of the batter...

Optional specially-modified high-performance Kevlar®-reinforced 513mm-long, 3mm-wide front drive belt.This belt is very thin and elastic as possibl...

The springs have been specifically designed to complement the big bore shocks. The spring rate is constant during the entire spring compression. Th...

Differential gears for gear differentials are made from pressed steel, heat treated, and machined for ultra-precision and smooth operation. Include...

This strong, lightweight rear axle is for use with XRAY gear diffs in 1/12 and 1/10 pan cars, as well as 1/10 formula cars. This super-light and to...

Xray Hex Screw SFH M2.5x6 (10) Fits Gear Diff

Xray Low Friction Kevlar Belt for T4'20

This is a pack of ten replacement XRAY 3mm Locknuts. These nuts feature an inner nylon ring for a secure hold.

This is a pack of ten replacement XRAY 3x10mm Set Screws, and are intended for use with the XRAY T2 009, T3, T3R and T3'12 1/10 touring cars, as we...

Xray M3x18 Hex Screw 903318

This is a set of replacement servo arms for the Xray XB8 line of buggies. This set of molded composite servo arms includes double-arm for throttle ...

This is a set of two replacement front suspension pivot pins for the XRAY T2 1/10th scale touring car. Lower outer pivot pins. Hardened for very hi...

This is a pack of two optional XRAY Black 1.2 Rate Side Springs. These springs are harder than the stock Gold springs.

This is a replacement XRAY Rear Drive Axle, and is intended for use with the XRAY XB4 1/10 4wd buggy. Package includes one rear axle.

The springs have been specifically designed to complement the big bore shocks. Set of 2. The spring rate of the linear springs is constant during t...

Silicone O-ring fits over 3mm shaft. 2mm thick. Set of 10 pieces

Xray Silicone O-Ring 3x2.1 (10)

Silicone O-ring fits over 5mm shaft. 2mm thick. Set of 10 pieces.

Silicone O-ring fits over 6mm shaft. 1.55mm thick. Set of 10.

**** 1.5mm chassis requires special low profile screws for installation, #913300. Standard countersunk screws will not fit and may cause damage to...